SENA Parani-BCD110V3 - Manual (Page 65)

Sena Technologies, Inc 65
B.3.41. AT+BTSEC,Authentication,Encryption
Response  OK
Purpose Set authentication and data encryption
Parameters Authentication=0: Inactivate (Default)
Authentication=1: Activate
Encryption=0: Inactivate (Default)
Encryption=1: Activate
Description If the authentication is activated, the pin code must be set by AT+BTKEY command.
Data encryption cannot be used when authentication is not enabled, i.e.
Authentication=0 and Encryption=1 will not work properly.
B.3.42. AT+BTNAME=$string
Response  OK
Purpose Change device name
Parameters $string = New device name (Default=BCD110_v3.0.0-445566)
Description Parani-BCD110V3 can have a user friendly name for easy identification. The name
allows up to 30 alpha-numeric characters.
Example AT+BTNAME=My-Parani-BCD
B.3.43. AT+BTLPM,n
Response  OK
Purpose Set low power mode
Parameters n=0: Inactivate (Default)
n=1: Activate
Description During no data transmission, Parani-BCD110V3 can be in low power mode to save the
power. Low Power Timeout is set to S-register S52. So if low power mode is activated
and if there is no data transfer during a period specified in S52, Parani-BCD110V3 will
be entered low power mode.
Please note that it takes a few seconds to make the Parani-BCD110V3 out of low power
mode.
B.3.44. AT&V
Response  S0:m0;S1:m1; …Sn:mn
 OK
Purpose Display all the S-registers
Description All parameters are stored at S-register in flash memory. These values are sustained
until hardware reset.