SENA Parani-BCD110V3 - Manual (Page 56)

Sena Technologies, Inc 56
(n=1 or n=2)
 TASK1 OK
TASK2 OK

TASK3 OK 
TASK4 OK 
TASK5 OK 
TASK6 OK 
TASK7 OK 
Purpose Set multiple connection mode
Parameters n=0: Single Connection Mode (Default)
n=1: Multi-Drop Mode
n=2: Node Switching Mode
Description Set single connection mode, multi-drop mode or node switching mode.
B.3.14. +++
Response  OK
Purpose Convert the operation status of ‘Connect’ to ‘Standby’
Description In ‘Connect’ status, data from host is transmitted to the other side Bluetooth device,
and any AT command is not accepted except this command, which is not echoed on
the screen.
When Parani-BCD110V3 encounters a character ‘+’ from host, it stops the data
transmission and waits for next 2 characters. If the next 2 characters are not ‘+’, it
restart to transmit data including the first ‘+’ as well. If so, it converts the operation
status to ‘Standby’.
If the data from host includes ‘+++’, it will convert the operation status to ‘Standby’.
Notice that Parani-BCD110V3 holds data transmission when it encounters ‘+’, until
receiving next character.
‘+’ is an escape sequence character by default, which is changeable by AT+SETESC
and stored at S-register 28.
B.3.15. - - - 
Response  OK
Purpose Convert the operation status of ‘SPP On-line’ to ‘Remote Configuration’
Description Basic operation of ‘---’ is same as that of ‘+++’. While ‘+++’ converts
‘Connect’ status to ‘Standby’ status, ‘---’ converts ‘Connect’ status to
‘Remote Configuration’ status.
‘-’ is a Remote Escape Sequence character by default, which is changeable
and stored at S-register 71.
B.3.16. AT+SETESC,nn
Response  OK