SENA Parani-BCD110V3 - Manual (Page 50)

Sena Technologies, Inc 50
Appendix B: AT Commands
B.1. Terminology
B.1.1. AT Command
AT command set is the in fact standard language for controlling modems. The AT command set
was developed by Hayes and is recognized by virtually all personal computer modems. Parani-
BCD110V3 provides the extended AT command set to control and configure the serial parameters
and Bluetooth connection.
B.1.2. AT Response
Parani-BCD110V3
replies to AT commands with 4 kinds of message, ‘OK’, ‘ERROR’, ‘CONNECT’ and
‘DISCONNECT’. The ‘CONNECT’ / ‘DISCONNECT’ response messages are divided into ‘CONNECT’
/
’DISCONNECT’, ‘SCOCONNECT’ / ’SCODISCONNECT’ and ‘IOPROFILECONNECT’
/ ’IOPROFILEDISCONNECT’.
B.1.3. Operation Mode
Mode Description
Mode0 Waiting for AT commands
Mode1 Attempting to connect to the last connected Bluetooth device
Mode2 Waiting for a connection from the last connected Bluetooth device
Mode3 Waiting for the connection from another Bluetooth device
B.1.4. Operation Status
Status Description
Standby Waiting for AT commands
Pending Executing tasks
Connect Transmitting data
B.1.5. Security
Security Description
Authentication Pin Code (or Pass key)
Encryption Data encryption