SENA ProBee-ZE20S - Manual (Page 54)

54 ProBee-ZE20S User Guide Rev.1.10
AT+PANID=7772
OK
ATS42=1
OK
AT+DESTLA=0001950000000001
OK
AT+GPIO=11111111111441111
OK
ATZ
OK
6.4.3 End-device Configuration
Hardware configuration for the end-device is as follows:
 Set the ADC_2 and ADC_3 switch to TEMP_SENS and LIGHT_SENS
The AT commands for coordinator configuration is as follows:
AT+NODETYPE=4
OK
AT+PANID=7772
OK
ATS42=1
OK
AT+DESTLA=0001950000000001
OK
AT+GPIO=11111111111441111
OK
ATZ
OK
6.4.4 Monitoring the Sensors
Once the configurations are done and the system is running, the terminal (computer) connected to the
coordinator will print out the incoming data as follows:
++0001950000000002|10000000000**0000|****,****,233E,006A,****,****
++0001950000000003|10000000000**0000|****,****,2254,0B23,****,****
++0001950000000002|10000000000**0000|****,****,2235,004E,****,****
++0001950000000003|10000000000**0000|****,****,226C,0B8B,****,****