SENA ProBee-ZE20S - Manual (Page 46)

46 ProBee-ZE20S User Guide Rev.1.10
To get/set the I/O values of the remote devices, remote AT commands can be used as below.
AT+REMOTE=,
Example)
AT+REMOTE=00019500000F3BA1,AT+DIO?
10001000111**0000
OK
5.2.2 Periodic Sampling
The ZE20S can be configured to send its I/O status to a remote device at a periodic rate. To configure this
way, please use the AT commands below:
AT+DESTLA= or AT+DL=
, where is the long address of a remote node to send sampled GPIO values of local
node.
ATS42=
, where is the GPIO sampling period in seconds. If set to 0, GPIO monitoring is disabled.
ATS43=
, where is the GPIO monitoring node. If set to 0, the monitoring node is selected by AT+DESTLA.
If set to is 1, the sink node is set as the monitoring node.
A device can be a sink node by setting S-register 61.The sink node multicasts its address to the other
devices in the destination group in the network according to the value of S-register 61, which is called
advertising.
ATZ
Reset the device to apply the changes
The ZE20S can be configured to display periodic sampling data coming from the other nodes. To enable
this feature, please use the AT command below:
ATS11=
, where determines whether incoming message will be presented or not. If a user wants to
display incoming message in command mode, S11 should be enabled.
If this feature is enabled, incoming message will display in the form of: