SENA UPSLink100 User Manual
Page 49

49
until the user presses the
address) and UART test are not performed.
If the user selects Looping (with External test in Auto test)’, auto test is performed repeatedly until the
user presses the
test are also performed repeatedly.
Note:
To perform the test on the Ethernet properly, the user must connect an Ethernet cable to the Ethernet
port of the UPSLink. There must exist a remote host with a valid IP address. The default server IP
address is 192.168.0.128 and it can be changed using the [Firmware Upgrade] menu. Otherwise, the
test may not be performed properly.
-------------------------------------------------------------------------------
Hardware Test
-------------------------------------------------------------------------------
Select menu
0. Test Mode - One time
1. Auto test
2. DRAM test
3. FLASH test
4. EEPROM test
5. Ethernet test
----->
----------------------------------------------------------------------------- --
Hardware Test
----------------------------------------------------------------------------- --
Select menu
0. Test Mode - Looping(without External test in Auto test)
1. Auto test
2. DRAM test
3. FLASH test
4. EEPROM test
5. Ethernet test
----->
----------------------------------------------------------------------------- --
Hardware Test
----------------------------------------------------------------------------- --
Select menu
0. Test Mode - Looping(with External test in Auto test)
1. Auto test
2. DRAM test
3. FLASH test
4. EEPROM test
5. Ethernet test
----->
----------------------------------------------------------------------------- --
Hardware Test
----------------------------------------------------------------------------- --
Select menu
0. Test Mode - One time
1. Auto test
2. DRAM test
3. FLASH test