SENA UPSLink100 - Manual (Page 17)

17
3. UPS management
3.1 UPS information
Once the UPSLink is connect to a UPS and communicates with the UPS through serial connection,
the basic information about the UPS is gathered and is shown on this page.
Figure 0-1 UPS information
UPS identification
Shows basic information that identifies the UPS and UPSLink
UPS test information
Shows UPS test related information if there is any test ever been initiated since the last start up of the
UPSLink. All of these fields are listed on RFC1628 UPS MIB.
UPS control information
If there is any ongoing countdown for UPS shutdown, startup or reboot, this section of the Web
displays the num ber of seconds left to the event.
The UPSLink has user customization features that enable adding user-specific information besides
above. Please refer to the document enclosed in the CD.