SENA UPSLink100 - Manual (Page 30)

30
To use the Dynamic DNS service provided by Dynamic DNS Network Services, the user must set up
an account in their Members' NIC (Network Information Center - http://members.dyndns. org). The
user may then add a new Dynamic DNS Host link after logging in to their Dynamic DNS Network
Services Members’NIC.
After enabling the Dynamic DNS service in the Dynamic DNS Configuration menu, the user must enter
the registered Domain Name, User Name, and Password. After applying the configuration change,
users can access the UPSLink using only the Domain Name.
Figure 0-3 shows the Dynamic DNS configuration web interface.
Figure 0-3 Dynamic DNS configuration
4.4 SMTP configuration
The UPSLink can send an email notification when an UPS alarm has been detected and/or when
scheduled time for system log messages expires. The user must configure a valid SMTP server to
send these automatically generated emails. The UPSLink supports three SMTP server types:
 SMTP without authentication
 SMTP with authentication
 POP-before-SMTP
These examples can be seen in Figure 0-4. Required parameters for each SMTP configuration
include:
 SMTP server IP address
 Device mail address
 SMTP user name
 SMTP user password
The device mail address specifies the sender’s email address for all log and alarm delivery emails.
SMTP servers often check only the sender’s host domain name of the email address for validity. .