SENA UPSLink100 User Manual
Page 43

43
To use either a Telnet or serial console to upgrade your firmware, the Telnet or terminal emulation
program must support Zmodem transfer protocol.
To upgrade firmware via Telnet or serial console:
1.
Obtain the latest firmware.
2.
Make connection using a terminal emulation program. (Telnet is recommended since the
process of firmware upgrade by serial console may be slower.)
3.
Select from the firmware upgrade menu as shown in Figure 0-10.
4.
Follow the online directions and transfer the firmware binary file using the Zmodem
protocol as shown in Figu re 0-11.
5.
Once the upgrade has been completed, the system will reboot to apply the changes
6.
If the firmware upgrade fails, the UPSLink will display error messages as shown in Figure
0-12. It maintains the current firmware version.
Welcome to UPSLink Configuration
Press Enter
Login : admin
Password : *****
-------------------------------------------------------------------------------
Welcome to UPSLink configuration page
Current time: 2003/05/19 10:32:22
F/W REV.
: 2.0.3
Serial No.
: UPSLINK-0304001
MAC Address: 00-01-95-04-20-30
IP mode
: Static IP
IP Address : 192.168.14.9
------------------------------------------------------------------- ------------
Select menu
1. UPS configuration
2. Network configuration
3. Serial port configuration
4. System Status & log
5. System administration
6. Save changes
7. Exit and apply changes
8. Exit and reboot
-----> 5
-------------------------------------------------------------------------------
System Administration
-------------------------------------------------------------------------------
Select menu
1. User administration
2. Device name : UPSLink 100
3. Date and time
4. Reload factory default settings
5. Reload factory default settings except IP setting
6. Firmware upgrade
-----> 6
*** Firmware upgrade will RESTART your device. ***
Are you sure to start firmware upgrade ? (y/n) : y
Preparing for firmware upgrade. Wait a moment...
Transfer firmware by zmodem using your terminal application.
**B01ff000005b157
Figure 0-10 Firmware upgrade using remote/serial console