SENA UPSLink100 - Manual (Page 23)

23
4. Network configuration
4.1 IP configuration
The UPSLink requires a valid IP address to operate within the user’s network environment. If the IP
address is not readily available, contact the system administrator to obtain a valid IP address for the
UPSLink. Please note that the UPSLink requires a unique IP address to connect to the user’s
network.
The users may choose one of three Internet protocols in setting up the UPSLink IP address: i.e.,
 Static IP
 DHCP (Dynamic Host Configuration Protocol)
 PPPoE (Point-to-Point Protocol over Ethernet)
The UPSLink is initially defaulted to DHCP mode. Table 0-1 shows the configuration parameters for all
three IP configurations. Figure 0-1 shows the actual web-based GUI to change the user’s IP
configuration.
IP address
Subnet mask
Default gateway Static IP
Primary DNS (Secondary DNS-Optional)
DHCP (Primary DNS/ Secondary DNS - Optional)
PPPoE Username
PPPoE Password
PPPoE
(Primary DNS/ Secondary DNS - Optional)
Table 0-1 IP Configuration Parameters
Figure 0-1 IP Configuration