SENA ProBee-ZE10 - Manual (Page 87)

87 ProBee-ZE10 User Guide Rev.1.5
Default 2
Range 0 – 2
9.3.6 S36
Description
Get/Set the maximum number of hops the message will be relayed. The message will
be delivered to all nodes within this number of hops of the sender. A value of zero is
converted to maximum value(30). It is used to multicast/broadcast.
Execute ATS36? ATS36=
Response
OK
OK
Default 0
Range 0 – 10
9.3.7 S37
Description
Get/Set the number of hops that the message will be forwarded by devices that are not
members of the group. A value of zero, 7 or greater is treated as infinite.
Execute ATS37? ATS37=
Response
OK
OK
Default 0
Range 0 – 7
9.3.8 S38
Description
Get/Set the receive message mode. If it is enabled, a local node will receive multicast
or broadcast messages from itself.
Execute ATS38? ATS38=
Response
OK
OK
Default 0
Range 0 – 1
9.3.9 S39
Description
Get/Set the receive mode. If S39 is enabled, a local node will only receive the same
type of messages with its transmission mode. For example, if local node’s
transmission mode is broadcast mode (AT+TM=3), it will receive only broadcast
messages and won’t receive unicast or multicast messages.
Execute ATS39? ATS39 =
Response
OK
OK