SENA ProBee-ZE10 - Manual (Page 76)

76 ProBee-ZE10 User Guide Rev.1.5
5 Reserved for pin-specific alternate functionalities (See Table 5-2)
7.10.2 AT+DIO
Description
Get/Set the digital IO value individually or all at once. All GPIO pins can be used as
digital IO and it is only possible to set 0 or 1. If there are some pins used analog input,
they are displayed by “*”.
Execute
AT+DIO? or
AT+DIO?
AT+DIO= or
AT+DIO=
Response
OK
OK or ERROR
Default 0000000000000
Range 0000000000000 - 1111111111111
7.10.3 AT+AI
Description
Get the analog input value individually or all at once. GPIO3~6 are possible to set ADC
and it’s read only. If there are some pins used digital IO, they are displayed by “****”.
Execute AT+AI? AT+AI?
Response
,,,
OK OK
7.10.4 AT+ SOURCELA or AT+SL
Description
Get/Set the 64-bit source IEEE address for GPIO remote control. It is possible to limit
on the implementation of this functionality by setting specific address. If set to default
value, “FFFFFFFFFFFFFFFF”, the node allows that any node can control the GPIO
status.
Execute AT+SOURCELA? AT+SOURCELA=
Response
OK
OK or ERROR
Default FFFFFFFFFFFFFFFF
Range 0000000000000000 – FFFFFFFFFFFFFFFF
7.11 Firmware Upload and Help
7.11.1 AT+BOOTLOAD or AT+BL
Description
Start bootloader to upload firmware. (blank: local, 1: passthru, 2: clone)
The device leaves the AT command line and enters the bootloader menu for uploading
new ProBee firmware. There’s no restrict to use local upload but a sleepy end-device
cannot upload to remote node over the air. The current UART should be set
115200bps, 8 data bits, no parity, 1 stop bit and none flow control.
Execute AT+BOOTLOAD AT+BOOTLOAD=,