SENA ProBee-ZE10 User Manual
Page 61
61
ProBee-ZE10 User Guide Rev.1.5
6.6.5.3 Temperature / Illumination Data at Coordinator
The AT commands for Sampling Temperature / Illumination at Coordinator:
++0001950000000212|11000**000000|****,****,21D6,0C72
++0001950000000212|11000**000000|****,****,21D0,0B87
++0001950000000212|11000**000000|****,****,21CB,0324
# Data changes after covering sensors with fingers
++0001950000000212|11000**000000|****,****,229B,0084
++0001950000000212|11000**000000|****,****,22A7,009E
++0001950000000212|11100**000000|****,****,22A9,002D
Data displayed at coordinator every second
Data format : ++<IEEE address>|
Refer to 6.6.7 Data Conversion about how to convert to analog data to temperature and
illumination
6.6.6
Periodic Sampling – Sink Node
6.6.6.1 Coordinator Configuration
The AT commands for Coordinator Configuration:
ATS11=1
# Set coordinator to receive incoming data
OK
# Response
ATS61=10
# Set coordinator to sink node which multicasts its
# address to the devices in AT+DESTGROUPID every 10 sec.
OK
# Response
ATZ
# Apply configuration
OK
# Response
6.6.6.2 Router Configuration
The AT commands for Router Configuration:
AT+DESTLA=0000000000000000
# Reset destination to send analog data (Destination address does not
# affect on sending analog data to sink node but reset destination to
# confirm that analog data are sent to sink node)
OK
# Response
ATS42=1
# Period to send analog data to sink node (unit : second)
OK
# Response
ATS43=1
# Set destination to sink node
# ATS43=0 sets destination to AT+DESTLA