SENA ProBee-ZE10 - Manual (Page 57)

57 ProBee-ZE10 User Guide Rev.1.5
6.6.1 Coordinator Configuration
Hardware configuration for the coordinator is as follows:

Set the HOST switch to USB

Close the USB_PWR jumper and open the RS_PWR and BATT_PWR jumpers.

Connect a USB cable between a host computer and the coordinator
The AT commands for the coordinator are as follows:
AT+NODETYPE=1 # Set node type as Coordinator
OK # Response
AT+PANID=7772 # Set 16-bit PAN ID (7772)
OK # Response
6.6.2 Router Configuration
Hardware configuration for the coordinator is as follows:

Set the ADC_2 and ADC_3 switch to TEMP_SENS and LIGHT_SENS
Figure 6-6 Hardware Configuration
The AT commands for the router are as follows:
ADC_2 ADC_3