Crown Audio DCi Series – Network Input Models - Manual (Page 23)

DriveCore Install Network Series Power Amplifiers
page 23 Operation Manual
Dual Mode Hi-Z (70V/100V) Mode
Typical input and output wiring, along with software
settings are shown in Figure 14. A 35Hz high pass filter
is selected automatically when the amplifier channel
is in Hi-Z or Bridged Hi-Z mode. Remember, DCi
amplifiers allow each channel Hi-Z or Low-Z mode of
operation to be selected independently, while 70V/100V
selection is global.
Figure 14 System Wiring for 70V/100V Operation
Figure 14
Always route the input and output wires in separate bundles.
Set-up and System Configuration
Note: 70/100V is global, while Low-Z/Hi-Z is per output channel