S&B Filters Cold Air Intake Kit - Cotton Filter 75-5054 - Manual (Page 2)

12.
Remove the OE filter gauge and rubber
grommet and insert the grommet into the
Filter Adapter
(G) , then insert the filter gauge.
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
10.
Use a flathead screwdriver to pry open
the OE hose clamp securing the crankcase
vent hose to the intake tube. Discard clamp.
13.
Attach the S&B Filter (E) to the Filter
Adapter (G) , secure with the #80 hose clamp
(F) .
20.
Install the Air Box (H) by placing the box
at an angle so that it secures around the OE
air inlet on the inner fender. Then push down
until the 3 prongs slide into the OE rubber
grommets. Use grease if necessary.
11.
Separate the vent hose from the intake
tube and remove intake tube from the vehicle.
21.
Place the Filter assembly into the Air
Box (H) , hook the bottom into the lip on the
Air Box.
16.
Place a #52 hose clamp (N) and a #56
hose clamp (P) on the Step Adapter (O) and
secure the larger end to the intake tube.
17.
Push the small end of the Intake tube
assembly over the turbo inlet. Leave the
connection loose for now.
19.
Place Air Box (H) in the area of the
installation and insert the OE hot air into Plug
for warm weather conditions or the Hole for
cold weather conditions.
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5054 / 75-5054D
14.
Remove the MAF sensor for the OE
cover and attach the MAF sensor to the Filter
Adapter
(G) . Use the MAF Gasket (I) and the OE
screws. For 2009 models use the supplied M4
screws
(Q) . Do not over tighten!
15.
Place two #72 hose clamps (J) over the
Hump Adapter (K) and slide the Hump
Adapter over the Intake Tube (L) until it is
flush with the end.
18.
For those concerned about minimal
engine heat; insert the Box Plug (R) into the
side of the Air Box (H) . For those seeking
additional air flow, set the Box Plug aside.
(See page 3 for more info)