S&B Filters Cold Air Intake Kit - Cotton Filter 75-5053 - Manual (Page 2)

14.
Remove the MAF sensor and ring
gasket from the OE air box lid. Insert the MAF
sensor and ring gasket into the Adapter Tube
(B) . Secure using the supplied M4 Screws
(N) . Do not over tighten the screws.
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (Continued)
12.
Line up the air inlet gasket and install
the Air Box (A) into the two OE rubber
grommets. Make sure the Air Box is fully
pushed down into the grommets. Secure
using the factory bolt removed in Step #6.
15.
Install the Silicone adapter (M) over the
turbo inlet using the two #72 Hose Clamps
(F) . Only tighten the hose clamp on the turbo
inlet at this time.
20.
Slide the Hump Adapter (L) over onto
the Adapter Tube (B) and tighten both #72
Hose Clamps (F) .
16.
Install the Hump Adapter (L) over the
Intake Tube (C) using the remaining two #72
Hose Clamps (F) until it is nearly flush with
the end of the tube.
18.
Install the Air Filter (D) onto the Adapter
Tube (B) and tighten the #80 Hose Clamp (E) .
19.
Carefully install the Filter/ Adapter
assembly in the Air Box (A) .
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5053 / 75-5053D
17.
Install the Intake tube assembly into
the Silicone Adapter (M) and tighten the #72
Hose clamp (F) .
10.
Place the large Rubber Washer (O)
over the threaded hole located on the
mounting tab on the battery tray.
13.
Remove the filter minder and grommet
from the OE air box lid. Insert the grommet
into the Adapter Tube
(B) and then reinstall
the filter minder.
11.
For those concerned about minimal engine heat; insert the Air Inlet Plug (T) into the side of the
Air Box (A) . For those seeking additional air flow, set the Air Inlet Plug aside. Plug will snap into
place and can be removed by taking the lid off and pushing from inside the air box. (See page 3 for
more info)