Installation instructions, P/n: as-5049, Vehicle application – S&B Filters Cold Air Intake Scoop AS-5049 User Manual
Page 2: Tools required, Before you start
1.
With the ignition switched off and the
parking brake set, disconnect the negative
battery cables on both batteries.
INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2003-09
Make: DODGE
Model: RAM 2500/ 3500
Engine: 5.9L / 6.7L DIESEL
(Standard chrome bumper only)
TOOLS REQUIRED
• 8mm Socket
• 18mm Wrench & Socket
• 7/16” & 1/2” Wrench & Socket
• 5/16” Nut Driver or Flat Blade Screwdriver
• Pliers
STANDARD CHROME BUMPER ONLY
NOTES
Kit may not fit with the following:
• Painted or Aftermarket Bumper
• Aftermarket Parts installed
• Body Lift or Lowering Kit
• Front Hitch
• Oversized Wheels and Tire
BEFORE YOU START
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 5 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not attempt to work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
4.
If equipped, remove the S&B splash
guard from the lower portion of the box using
7/16” socket. Retain the screws, large flat
washers and lock washers.
7.
Slide the Scoop Main Channel
(A)
over
the Scoop Base
(B)
and secure starting the
back using the supplied 1/4”-20 hex bolts
(E)
,
flat washers
(F)
, and lock washers
(D)
.
2.
Using a 8mm socket locate and remove
the (8) screws from the wheel well liner.
5.
From under the truck, remove the two
nuts behind the bumper on either side of the
frame using a 18mm socket.
8.
Secure the front using the other 1/4”-20
Hex Bolts
(E)
, flat washers
(F)
, and lock
washers
(D)
to the front of the scoop.
3.
Using a pair of pliers, push the pin
attaching the wiring harness to the inside.
Then remove the wheel well liner from vehicle
by pushing it in and then down to remove.
6.
Apply a small amount of the supplied Blue
Loctite to (4) 1/4”-20 Hex Bolts
(E)
.
9.
Apply a small amount of the supplied
Blue Loctite to the (4) 5/16”-18 Hex Bolts
(G)
.
P/N: AS-5049
SEE EXPLODED VIEW ON PAGE 5
2
Important: Read warning page prior to proceeding.