S&B Filters Cold Air Intake Scoop AS-1006 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2009-13
Make: Dodge
Model: Ram 1500
Engine: 5.7L Hemi
OE DODGE BUMPERS ONLY
NOTES
Kit may NOT fit with the
following:
• Aftermarket Bumper
• Body Lift or Lowering Kit
• Front Hitch
• Oversized Wheels and Tires
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
4.
Secure the Mounting Bracket (B) to the Scoop (A) using the supplied 1/4-20x1.0” Screws (D) ,
1/4” Split Lock Washers (E) and 1/4” Flat Washers (F) on the front side and 1/4” Flat Washers (F)
with 1/4-20 Lock Nuts (G) on the inside. Tighten using 7/16” socket while holding the nut on the
inside using a 7/16” wrench.
2.
If you already have the S&B intake
installed with the Air Inlet Plug; remove the
two screws by reaching up under the truck
behind the wheel liner using a 7/16” wrench to
loosen. (If not, skip this step)
5.
From under the truck; remove the bumper
mounting nut using a 18mm socket.
P/N: AS-1006
SEE EXPLODED VIEW ON PAGE 4
2
Important: Read warning page prior to proceeding.
BEFORE YOU START
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 5 are present.
• If you are missing any of the components, call our customer support
at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the
Parking Brake is set.
Thread Locker Use
We have provided a small tube of thread locker in
your kit. Whenever you see the symbol above on a step
of the instructions apply 1 small drop of the thread locker
to the threads of the screws or bolts. This will keep your
hardware from vibrating loose during rough driving. If the
hardware ever needs to be removed, do so slowly to
avoid having the inserts strip out from the plastic. DO
NOT USE ON LID HARDWARE, MAY CAUSE CRACKS.
7.
Carefully slide the scoop assembly up
into the engine compartment at an angle
(shown below). Note the bracketʼs position so
you donʼt scratch the front bumper or bend
the bracket.
8.
Slide the Scoop Assembly up into the
bottom of the air box at angle that allows the
support tab to slide into the scoop channel.
9.
Attach the scoop channel to the air
inlet tube using two 1/4-20x1.0” Hex Screws
(D) and 1/4” Flat Washers (F) . Tighten both
using a 7/16” wrench.
TOOLS REQUIRED
• 3/8”, 1/2” Drive Ratchets
• 7/16”, 18mm Sockets
• 10mm, 7/16” Wrenches
3.
Install the two 1/4-20 Clip Nuts (C) to the
top of the Scoop (A) . Push down until they
“snap“ into the holes.
1. With the ignition switched off and the
parking brake set, disconnect the negative
battery cable on the driver’s side.