S&B Filters Cold Air Intake Kit - Cotton Filter 75-2503 - Manual (Page 2)

1/9/2008
PERFORMANCE TESTING
∗
Engage parking brake and start your engine. To en-
sure that the system was installed properly, listen for
abnormal noises. If an air leak is detected, re-inspect
hoses and connections as they may need to be tight-
ened.
∗
S&B FILTERS RECOMMENDS THAT YOU KEEP
YOUR OEM INTAKE SYSTEM IN THE EVENT IT IS
REQURIED IN THE FUTURE.
∗
In order to maintain proper warranty, all connections
and components must be checked periodically for re-
alignment and to tighten all connections. Failure to do
so will void your warranty.
∗
Use only S&B cleaning and oil products to service
your filter. Using other company’s oil and cleaner
products may void your warranty.
Call (909) 947-0015 should you have any
questions or comments.
787 S. Wanamaker, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
12. Cut and install vent hose.
13. Reconnect the negative battery cable
and check all of the final assembly
connections to ensure that all
connections are tight.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog check
inspection when a High Performance
Intake Kit has been installed.
You must place the E.O. label provided
on or near the intake kit after installation
so that a smog check technician can
easily verify the E.O. number.