beautypg.com

Installation instructions, Continued) – S&B Filters Cold Air Intake Kit - Cotton Filter 75-2514-4 User Manual

Page 2

background image

3/17/2009
REV-D

(909) 947-0015 Phone • (909) 947-0603 Fax

www.sbfilters.com

INSTALLATION INSTRUCTIONS

(continued)

13. Twist and pull to remove the air
temperature sensor from the OE intake tube.

14. Install the rubber grommet provided into
the S&B intake tube and then carefully
insert the air temperature sensor into the
grommet.

17. Install the heat shield to the inner fender
bracket and secure using the 1/4”-20 x 3/4”
bolts and fender washers.

18. Install the step adapters and appropriate
hose clamps onto the S&B intake tube.

19. Install the S&B intake tube onto the
throttle body and MAF sensor housing.

21.(a) On 4.6L Engines: Cut the 3/4”x6” hose
down to about 3” to bridge the upper port
on the intake tube to the air bypass valve,
secure with #8 hose clamps.
Reconnect lower vent line to the intake tube’s
lower port, secure with #8 hose clamp.

22. Reconnect MAF sensor connections.

21.(b) On 5.4L Engines: Attach the provided
3/4”x6” hose to the crank case vent line and
secure both the vent and idle air control lines
to the S&B intake tube. Use the #8 Hose
Clamps. If the OE vent line allows, you may
cut the provided hose shorter as pictured
below.

23. Install the S&B air filter and tighten hose
clamp.

24. Inspect your installation, make sure
kit is properly positioned and all fasteners
are tight. Reconnect the battery.

15. Remove the OE rubber grommets from
the inner fender bracket.

16. Install the speed nut clips to the inner
fender bracket.

20. Reconnect the air temperature sensor
electrical connection..

After installing the S&B Intake kit, some
4.6L engines may generate a whistling
sound at the air bypass valve. To elimi-
nate the whistle remove the valve and
cut the flange of the air bypass valve just
up from the last barb, deburr the edge
and re-install the valve.

25. Affix the C.A.R.B. exemption sticker in
plain sight under the hood near the intake
system.