S&B Filters Cold Air Intake Kit - Cotton Filter 75-5038 - Manual (Page 2)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
10. Slide the large side of the Hump Adapter
(J) over the large end of the S&B Intake Tube
(O) until the small side hits the end of the
tube.
14. Peel the backing from the MAF Sensor
Gasket (H) before placing it over the sensor,
sticky side down.
11. Place the # 60 Hose Clamp (N) over the
turbo inlet and a # 64 Hose Clamp (L) over
the filter adapter (K). Then slip the S&B Intake
Tube assembly over the turbo inlet, align the
large end of the tube to the filter adapter then
secure the # 60 hose clamp (N).
15. Place the M4 screws (I) through the
MAF mounting holes, then place the Rubber
Washers (G) over the screws. Insert the MAF
sensor into the S&B Filter Adapter (K) (note
the direction of air flow) and tighten the M4
screws evenly. Do Not Over Tighten!
12. Slide the S&B Hump Adapter (J) over
the filter adapter (K), center over the gap
between the tubes and secure the #72 and
#64 Hose Clamps (L).
16. Reconnect the MAF sensor electrical
connection.
19. Place the clear lid on the air box and
secure using the 8/32 SS Screws (A) and SS
Washers (B).
13.
Use the T-20 Security Torx Tool supplied
and remove the MAF Sensor from the OE air
box.
17. Place the S&B Air Filter (D) into the S&B
Air Box (E), slide onto the flange and secure
the # 80 Hose Clamp (F).
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5038 / 75-5038D
18.
Remove the protective covering from
the S&B Clear Lid (C).
20.
Reconnect both negative battery cables.
Inspect your installation, make sure kit is
properly positioned and all fasteners are tight.
#64
#60