S&B Filters Cold Air Intake Kit - Cotton Filter 75-5008 - Manual (Page 2)

9/12/2006
REV-B
INSTALLATION INSTRUCTIONS
(continued)
18. Install the air temperature sensor
into the rubber grommet on the S&B
intake tube.
14. Install the twisted bracket to the air
box. Use the rubber washer and the
1/4” washer provided.
NOTE: Make sure there is adequate
clearance between the intake tube and
the engine pulley.
19. Reconnect the electrical connection
for the air temperature sensor.
15. Use the OE 10mm bolt removed in
step # 7 to secure the S&B air box
bracket to the OE air box mount.
20. Install the clear lid onto the S&B air
box.
16. For the 5.7 L applications Insert the
1/2” 90 degree hose barb into the intake
tube grommet….
21. Re-connect the negative battery
cable. Inspect your installation, make
sure kit is properly positioned and all
fasteners are secure.
Smog Certification Note:
The California Air Resource Board (CARB)
requires an that an E.O. identification label
be applied to the vehicle in order to pass a
smog check inspection when installing a
High Performance Intake Kit.
You must place the E.O. label provided on or
near the intake kit after installation so that
the smog technician can easily verify the
O.E. number during the smog certification
process.
17. For the 5.7 L applications with a short
OE vent line, use the 1/2” x 10” long hose
and straight hose mender to extend the
crank case vent hose to intake tube….
Testing & Warranty Info:
1. Engage parking brake and start your engine.
To ensure that the system was installed
properly, listen for abnormal noises. If an air
leak is detected, re-inspect hoses and con-
nections as they may need to be tightened.
2. We recommend that you keep your stock
(OEM) intake system in the event that is
required in the future.
3. All connections and components must be
checked periodically for realignment, clean-
ing and retighten of all connections. Failure
to do so may void your warranty.
5. We recommend that you only use S&B oil
and cleaner products to service your filter.
Using any other manufacturer’s products
may void your warranty.
787 S. Wanamaker Ave, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
Part No. 88-0005
Order online today at www.sbfilters.com
or though your local S&B Distributor
NOTE: Use this twisted bracket for
the 2005 vehicles….
….use this twisted 45 degree bracket
for 2006 and newer vehicles.
….. With a long OE vent line, simply route
the line to the 90 degree fitting and cut to
length.
...for the 6.1L applications insert the
1/2” straight hose barb into the intake
tube grommet and use the S&B hose.