Powersolve SM3000 Series - Manual (Page 5)

SM3000
Rev. Sept. 2012 SPECIFICATIONS Page 1 - 5
Typical Applications
• Solar inverter testing, PV-Simulation • Automotive battery simulations • Driving PWM-controlled DC-motors
• Plasma chambers • Controlled battery (dis)charging • Accurate current sources
• Hybrid Car test systems • Lasers • Aerospace and military equipment
• ATE in industrial production lines
In creased Out put Power
The conservatively rated unit
allows to deliver extra output with
the same reliability.
At some derating, either the maximum output
voltage or the maximum output current can be
increased by about 10%.
• Order Code - P069
Notes: 1. Down load spe cial datasheet about High Speed Pro gram., Power Sink and Bat tery Charg ing from
www.powersolve.co.uk
2. There is only room for one of the in ter faces in a unit (P145, P146, P149, P164, P275, P276)
Available Options
High speed
pro gram ming
A 10 to 20 times higher
programming speed (down to
0.33 ms rise time at full load)
and lower output capacitance.
Excellent for laser applications, test systems or
as current source with low parallel capacitance
as used in plasma chambers.
• Order Code :
SM 15-200 D P104 - SM 70-45 D P032
SM 30-100 D P031 - SM 120-25 D P106
SM 45-
70 D P105 - SM 300-10 D P061
Two-Quad rant
Out put: Power sink
Two quadrant operations
maintains the output voltage
constant regardless the
output power is positive or negative. Ideal
for PWM-speed controlled DC-motors and
ATE systems.
• Order Code :
SM 15-200 D P127 - SM 45-70 D P129
SM 30-100 D P128 - SM 70-45 D P130
Sequencer
Arbitrary Waveform generator or
standalone automation.
The sequencer is integrated in the
Ethernet controller.
• Order Code - P149
High Volt age Isolation
A higher output isolation allows
series operation up to 1000V.
• Order Code - P089
Se cured Volt age
and Cur rent Set ting
For a maximum security,the
CV/CC settings can be
adjusted with a screwdriver
only and are protected with a plastic cap
from accidental adjusting.
• Order Code - P001
Soft ware con trol
and in ter faces
Factory installed
programming interfaces:
• ISO AMP Card - isolated analog - P145
• RS232 controller - P146
• IEEE488 controller - P164
• Ethernet controller (incl. sequencer) - P149
• PROFIBUS controller - P275
• CANBUS controller - P276
0,4ms