Sena Bluetooth SMH10R v4.3 User's Guide - Manual (Page 19)

English
SMH10R
19
Note:
You have to use a motorcycle specific GPS which transmits turn-by-
turn voice instruction to the headset by Bluetooth. Most automotive GPS
systems don’t have this feature.
7.5 Pairing with the Sena SR10 Bluetooth Two-way
Radio Adapter
The Sena SR10 is a Bluetooth two-way radio adapter for group
communication, and uses HFP as do most motorcycle specific
GPS navigation systems. If you pair the SMH10R with an SR10 by
multipoint pairing, the SMH10R is able to have two HFP devices at the
same time: a mobile phone and the Sena SR10.
1.
To enter the voice configuration menu, press and hold the
Center Button for 10 seconds until you hear the voice prompt,
“Configuration menu”.
2. Press the (+) Button twice and you will hear the voice prompt,
“Multipoint pairing”.
3. Turn on the SR10 and follow the SR10’s “Bluetooth Headset Pairing”
procedure to complete the process. Please refer to the SR10 user's
guide for details.
4. When the pairing is completed, you will hear the voice prompt,
“Your headset is paired”.
5. If the pairing process is not completed within three minutes, the
SMH10R will return to stand-by mode.
The incoming audio from the two-way radio via SR10 is heard
in the background while having an intercom conversation or a
mobile phone call. You can listen to music, answer a mobile call,
have an intercom conversation and use a two-way radio via the
SR10 for group communication as shown in the figure below. A
GPS navigation or a radar detector that has a headphone jack
or audio line-out could be connected to the SR10 by wire. GPS
voice instruction or the radar detector alarm can also be heard in
the background via SR10 while having an intercom conversation
or phone call. Please refer to the SR10 user's guide for details.