Sena Bluetooth SMH10R v4.3 User's Guide - Manual (Page 12)

SMH10R
12
6.3 Phone Selective Pairing
Voice Prompt “Phone selective pairing”
Factory Default N/A
To go into phone selective pairing mode, tap the (+) Button or
the (-) Button until you hear the voice prompt, “Phone selective
pairing”. Please refer to section 8 for more details on phone
selective pairing. If you tap the (+) Button or the (-) Button, you
can exit from the phone selective pairing mode.
6.4 Media Selective Pairing
Voice Prompt “Media selective pairing”
Factory Default N/A
To go into media selective pairing mode, tap the (+) Button or
the (-) Button until you hear the voice prompt, “Media selective
pairing”. Please refer to section 8 for more details on media
selective pairing. If you tap the (+) Button or the (-) Button, you
can exit from the media selective pairing mode.
6.5 Assigning Speed Dial
Voice Prompt “Speed dial”
Factory Default N/A
Execute Tap the Center Button
1. To assign a phone number as a speed dial, tap the (+) Button
or the (-) Button until you hear a voice prompt saying “Speed
dial”.
2. Tap the Center Button, and you will hear a voice prompt
saying “Speed dial one” and “Phone connected”.
3. Tap the (+) Button or the (-) Button to select one of three
speed dial numbers and you hear a voice prompt saying
“Speed dial (#)”.
4. Call a phone number you want to assign and you will hear
a voice prompt saying “Save speed dial (#)”. The phone
number is automatically assigned to the selected speed
dial number. Then the phone call will hang up before being
connected.
5. To exit the menu, tap the (+) Button or the (-) Button until you
hear a voice prompt saying “Cancel”, and tap the Center
Button to confirm. You will then hear a voice prompt saying
“Cancel”. If any button is not pressed within 1 minute, the
SMH10R will exit the configuration menu and go back to
stand-by mode.