B&B Electronics ESU2-400 - Manual - Manual (Page 11)

USB-to-Serial Adapter User’s Manual Installing the software
Rev 1.01 (February 2007) Page 7
Installing under Windows 2000
Follow these steps to install the USB-to-Serial adapter under
Windows 2000.
Step Procedure Description

Step 1 Turn on the power to your computer
system.
This is the system in which the device is to
be installed.

Step 2 Plug the wide flat end of the USB cable
into the downstream connector.
This is the connector located on the back of
the computer of USB hub.

Step 3 Plug the square end of the USB cable into
the back of the USB-to-Serial adapter.
Windows tells you that it has found new
hardware and launches the Add New
Hardware Wizard. The Found new
hardware prompt displays.
Figure 6 - Windows 2000 Found new hardware prompt
Step Procedure Description

Step 4 Click the Next button. The Search for or display drivers
prompt displays.
Figure 6 illustrates the
Windows 2000 Found new
hardware prompt. The Found
New Hardware Wizard
launches automatically when
you first plug in the USB-to-
Serial adapter.