B&B Electronics 858-18121 - Manual - Manual (Page 9)

5
Installing an IE-iMcV-MultiWay
IE-iMcV-MultiWay can be installed in IMC networks’ unmanaged MediaChassis, IE-
MediaChassis series, or the iMediaChassis series.
To install an IE-iMcV-MultiWay
1. Remove the blank bracket covering the slot where the module is to be
installed by removing the screws on the outside edges of the bracket.
2. Slide the iMcV-Modules into the chassis, via the cardguides, until the
module is seated securely in the connector.
3. Secure the module to the chassis by tightening the captive screws.
4. Save any “blanks” removed during installation for future use if the
configuration requirements change.