B&B Electronics 858-18121 - Manual - Manual (Page 46)

42
Connecting the IE-iMcV-MultiWay to an iMcV-Giga-FiberLinX-II
If the IE-iMcV-MultiWay is being set up as a Remote (CPE) to a Host connection with
an iMcV-Giga-FiberLinX-II, iView
2 provides support for SNMP management of the
pair. Several pairs can be managed via UMA through the SNMP management
module on the same IP address.
For information or instructions on the use of Unified Management Agent (UMA) refer
to the SNMP Management module manual. Please refer to
www.imcnetworks.com .
Configuration File Save/Restore Function
Requirements
The Configuration File Save/Restore Function allows a user the ability to backup all
the configuration settings of a unit. With this backup, a user can restore settings to a
unit if necessary or use this backup to apply the same settings to a different unit.
All configurable managed objects are saved in a configuration file that is stored in the
unit’s Large File Area. This includes all configurable settings such as VLAN
configurations, IP Address configuration and SNMP agent settings. The configuration
file can be transferred from the unit to a PC and saved to disk through the iView
2
(iConfig view) protocol. The configuration file can be transferred from a PC to a unit
of the same type through iView
2 (iConfig view) or TFTP into the unit’s Large File Area.
After the transfer is complete, the unit copies the configuration to flash and reboots.