B&B Electronics 856-19717--57 - Manual - Manual (Page 17)

14
Rebooting the Unit
To reboot the IE-MiniFiberLinX-II, type reboot.
Enabling/Disabling DHCP
To toggle DHCP on the IE-MiniFiberLinX-II between enable and disable, press D.
Additional Device-Specific Commands
The IE-MiniFiberLinX-II also includes the following device-specific options.
To access these options, perform the following:
1. Press the Space Bar when in the Command List section of the Main
Configuration screen (serial configuration/Telnet session).
2. Type the name of the action (shown below) and press Enter.
cleandb Reboots the unit with a clean database. This removes all information
from the database and sets the unit to factory defaults.
download Downloads firmware via the TFTP protocol
ifStats Displays Ethernet statistics
rmStats Displays RMON statistics
version Displays the unit’s serial number and build date
reboot Reboots the unit and clears all internal counters.
security Allows ARP request configuration. This setting is only for very unique
configurations and should not be adjusted.
port Displays and changes port settings, such as duplex status and speed.