Rainbow Electronics ATA6824 - Manual (Page 4)

4
4931C–AUTO–09/06
ATA6824 [Preliminary]
3. General Statement and Conventions
• Parameter values given without tolerances are indicative only and not to be tested in
production
• Parameters given with tolerances but without a parameter number in the first column of
parameter table are “guaranteed by design” (mainly covered by measurement of other
specified parameters). These parameters are not to be tested in production. The tolerances
are given if the knowledge of the parameter tolerances is important for the application
• The lowest power supply voltage is named GND
• All voltage specifications are referred to GND if not otherwise stated
• Sinking current means that the current is flowing into the pin (value is positive)
• Sourcing current means that the current is flowing out of the pin (value is negative)
3.1 Related Documents
• Qualification of integrated circuits according to Atmel ® HNO procedure based on AEC-Q100
• AEC-Q100-004 and JESD78 (Latch-up)
• ESD STM 5.1-1998
• CEI 801-2 (only for information regarding ESD requirements of the PCB)
22 CPHI I
Charge pump capacitor 220 nF/25V/X7R
23 CPLO O
24 VG I/O Blocking capacitor 470 nF/25V/X7R
25 PBAT I Power supply (after reverse protection) for charge pump and H-bridge
26 L2 O Gate voltage H-bridge, low-side 2
27 L1 O Gate voltage H-bridge, low-side 1
28 PGND I Power ground for H-bridge and charge pump
29 VCC O 5V/100 mA supply for microcontroller, blocking capacitor 2.2 µF/10V/X7R
30 VBAT I Supply voltage for IC core (after reverse protection)
31 VBATSW O 100
Ω
PMOS switch from V
BAT
32 NC – Not connected
Table 2-1. Pin Description (Continued)
Pin Symbol I/O Function