Rainbow Electronics RC1180-MBUS - Manual (Page 12)

RC1180-MBUS
 2008 Radiocrafts AS RC1180-MBUS Data Sheet (rev. 1.0) Page 12 of 28
OFF IDLE
t
OFF-IDLE
SLEEP IDLE
t
SLEEP-IDLE
RESET IDLE
t
RESET-IDLE
CONFIG CONFIG
t
C-CONFIG
IDLE
t
CONFIG-IDLE
’C’ ’X’
CONFIG
MEMORY CONFIG
CONFIG
t
MEMORY-CONFIG
’M’ 0xFF
IDLE
t
CONFIG-IDLE
’X’
IDLE
t
CONFIG-PROMPT
CONFIG
set low
Symbol Value Description / Note
t
RX-TXD
TBD us Time from last byte is received from the air until first character is sent
on the UART
t
TXD
Min TBD us t
TXD
= # bytes received x 621 us/char (10 bits at 19.2 kBd + 100 us
delay per character)
t
TXD-IDLE
TBD ms Time from last character is sent on the UART until module is in IDLE
mode (ready for RXD and RX)
T
RXD-CTS
TBD us Time from last character is received by the UART (including any
timeout) until CTS is activated
t
RXD-TX
TBD ms Time from last character is received by the UART (including any
timeout) until the module sends the first byte on the air.
T
TX-IDLE
TBD ms Time from last character is sent on the air until module is in IDLE
mode (ready for RXD and RX)
t
OFF-IDLE
TBD ms
t
RESET-IDLE
TBD ms
t
SLEEP-IDLE
TBD ms
t
CONFIG-
PROMPT
TBD ms Time from 00h / CONFIG pin is set low until prompt (“>”)
t
C#-CONFIG
TBD ms Delay after channel-byte is sent until prompt (“>”). (For other
commands like ’M’, ’T’ there is no delay but immediate prompt)
t
MEMORY-
CONFIG
TBD ms In this period the internal flash is programmed. Do not reset, turn the
module off, or allow any power supply dips in this period as it may
cause permanent error in the Flash configuration memory. After 0xFF
the host should wait for the ‘>’ prompt before any further action is
done to ensure correct re-configuration.
T
CONFIG-
IDLE
TBD ms
t
TX
Min TBD ms t
TX
= # bytes to send x 1.67 ms/byte (at 4.8 kbit/s). Add 13 overhead
bytes if addressing and CRC is not used. Add additionally 2 extra
bytes for addressing and 2 extra bytes for CRC if enabled.