Cobalt Digital FUSION 3G 9985 3G_HD_SD Loudness Processor - Manual (Page 40)

2
Installing a Rear Module
2-4 9985 PRODUCT MANUAL 9985-OM (V1.18)
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Installing a Rear Module
Notes: • This procedure is applicable only if a Rear Module is not currently
installed in the slot where the 9985 is to be installed.
• Where options are furnished using a piggyback card mounted to 9985 main
card, base Rear Module must be installed in frame location such that Rear
Module interfaces with base card. Expansion Rear Module must be
installed in frame location such that Rear Module interfaces with expansion
(piggyback) card (see Figure 2-3).
• Note that some Rear Modules and labels have several ventilation holes. To
allow maximum ventilation, it is recommended to place the label fully over
connectors such that label is flush with rear module and holes are not
obscured. Also, when a card is not installed in a slot, it is recommended that
the supplied blank cover be used to preserve proper forced ventilation
flow-through.
The full assortment of 9985 Rear Modules is shown and described in 9985
Rear Modules (p. 2-7). Install a Rear Module as follows:
1. On the frame, determine the slot in which the 9985 is to be installed.
2. In the mounting area corresponding to the slot location, install
Rear Module as shown in Figure 2-2.
3. If an expansion Rear Module is to be installed, install it adjacent to the
base Rear Module as shown in Figure 2-3.