Cobalt Digital COMPASS 9284 3G_HD_SD-SDI 8X4 Video Routing Switch - Manual (Page 42)

3
Operating Controls Overview
3-8 9284 PRODUCT MANUAL 9284-OM (V1.3)
Operating Controls Overview
The card has several function submenus (“tabs”) which are used as follows,
and typically in the order listed here for initial setup.
• Module Settings tab – Items in this tab set global parameters for the
card, such as the frame reference source to be used, video format and
frame rate, and the VBI line where switching is to be performed.
Items in this tab should be set first before proceeding to other tabs
or attempting to use the card for switching.
• I/O Settings tab – Items in this tab allow custom names to be applied
to the card source inputs and destination outputs. Also provided are
channel properties controls that enable or disable input EQ, output
reclocking, and alarm enable/severity level for each input and output
channel.
• Salvos tab – Items in this tab allow configuring the
source-to-destination routing for up to 10 user-defined salvos using a
source-to-destination selection matrix. Also provided are fields in
which each salvo can be given a custom name if desired.
• Control tab – This is the tab from which a salvo is launched. When
inputs/outputs and salvo routing are defined (as described for the
above tabs), the salvos will be identified by the names you have
entered, as well as the routing defined for each salvo.
• Host Settings tab – These controls are reserved.
• Panel Settings tab – These controls are reserved.