Cobalt Digital COMPASS 9284 3G_HD_SD-SDI 8X4 Video Routing Switch - Manual (Page 34)

2
Setting Up 9284 Network Remote Control
2-4 9284 PRODUCT MANUAL 9284-OM (V1.3)
Figure 2-2 Rear I/O Module Installation
Setting Up 9284 Network Remote Control
Perform remote control setup in accordance with Cobalt ® reference guide
“Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide Remote
Control User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™.
Download a copy of this guide by clicking on the
Support>Reference Documents link at www.cobaltdigital.com and then
select DashBoard Remote Control Setup Guide as a download, or contact
Cobalt
® as listed in Contact Cobalt Digital Inc. (p. 1-26).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2