beautypg.com

Installing a rear i/o module, Figure 2-1, Installation and setup – Cobalt Digital COMPASS 9284 3G_HD_SD-SDI 8X4 Video Routing Switch User Manual

Page 33

background image

9284-OM (V1.3)

9284 PRODUCT MANUAL

2-3

Installation and Setup

Installing a Rear I/O Module

Figure 2-1 9284 Rear I/O Module Connections

Installing a Rear I/O Module

Note:

This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9284 is to be installed.

Install a Rear I/O Module as follows:

1.

On the frame, determine the slot in which the 9284 is to be installed.

2.

In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.

Connect cabling as shown. Unused connectors do not require external termination.

Serial RS-232 control port pinout is as follows:
Pin 2 TX
Pin 3 RX
Pin 5 GND

PANEL RS-485 port is reserved.

See also other documents in the category Cobalt Digital Accessories for video: