Speedhut CJ (Jeep) Speedometer Cluster - Manual

CJ GPS Speedometer Cluster
Button - Used to operate gauge screen and programming
menus and options.
Gauge Mounting Brackets - 4 in total,
one on each corner of the gauge.
Screen - Displays - milage,
programming options,
menus, and other useful
information.
High Beam Indicator Check Engine Indicator
Brake Indicator
Left Turn Signal
Right Turn Signal
4 Wheel Drive
(4x4) Indicator
Low Fuel Indicator
Temperature
Warning Indicator
FIGURE 1: Gauge Display Guide
Temperature Gauge
Fuel Level Gauge
Speedometer
Tachometer (Not available on some models)
- 1 -
Installation Instructions
1. Disconnect the vehicle battery.
2. Connect the gauge power requirements as shown in figures 2 & 3.
3. Wire all the components to the proper sources and senders. (See figures 2 & 3)
3. Reconnect the vehicle battery.
4. Power up the gauge and program the various gauge components (if needed). (See Gauge Operation
Instructions)
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the product circuit board will be free from defects in materials or workmanship.
Please contact Speedhut service department If you have a problem with this gauge.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST)