Speedhut 2-1_16 inch & 2-5_8 inch GPS Speedometer - Manual

Ground (black)
+12 volts Dash lighting (white)
Peak recall button to recall peak
Snap connection
for dial lighting
+12 Volts keyed ignition (Red)
(Black) Ground
(White) +12 Volts Dash lighting
Power distribution cable to plug all gauges into
Inverter
Note: Tie together the
+12volt dash lighting white
wire to the +12 volt inverter
white wire and connect to
the same dash lighting
source.
+12Volts Hot Start (Red with black)
This feature draws very low current
and will not drain battery under normal use.
1. Hook up speedometer power requirements as shown above.
2. Plug GPS receiver antenna into back of speedometer.
4. Hot start feature is optional. Hooking up the Hot start wire to constant +12volts allows GPS to quickly acquire satellites in less than 2 seconds.
This feature saves your current satellite position within the speedometer enabling it to quickly restore your position on power up when
to the satellites
The current draw is extremely low and will have virtually zero impact on a car battery’s charge.
Hotsart wire should be connected directly to battery +12volts and should remain powered 100% of the time.
3. For best performance, mount GPS antenna with as much view of sky as possible (preferably on the roof of the vehicle). The GPS antenna is
waterproof and magnetic. If the car’s roof is not accessible then mount the antenna on top of the vehicle’s dash with as much exposure as possible
plastic. All types of
metal will block the signal.)
2-1/16” And 2-5/8” GPS Instructions
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship. Please contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
(Main gauge power)
(Pointer (needle) lighting)
(Gauge Dial lighting)
INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Inverter Note: E18-686-5CR is single gauge inverter to light single gauge.
C01-18N-2 & C11-18A01 are multiple gauge lighting inverters that can light
up to 6 - 8 gauges depending on inverter model.