Speedhut Freedom CAN-bus Gauge Installation - Manual

Freedom CAN-bus Gauge Instructions
Ground (black)
+12 volts Dash lighting (white)
Snap connection
for dial lighting
+12 Volts keyed ignition (Red)
(Black) Ground
(White) +12 Volts Dash lighting
Power distribution cable to plug all gauges into
(green with yellow)
(green with red)
(blue with white)
**left turn signal +12V pulse
**right turn signal +12V pulse
**high beam wire +12V
Inverter
E18-686-5CR
C01-18N-2
C11-18A01
Note: Tie together the
+12volt dash lighting white
wire to the +12 volt inverter
white wire and connect to
the same dash lighting
source.
Turn signals and High Beam Indicator (if applicable)
Figure 1: Gauge Power and Lighting Setup
Figure 2: OBDII and Daisy Chain Setup
Note: A set of Freedom CAN-bus
Gauges can be daisy chained
together in any order.
Daisy Chain Jacks
CAUTION: Do not connect the Daisy Chain while
connected to a powered OBDII system.
Failure to do so will throw a check engine code.
RED
BL
A
To OBDII connector
or wire it direct to
CAN high and
CAN low ECU lines.
CAN high
OBDII
CAN l
ow
OBDII Option:
Wire Direct Option:
Does your vechicle support the CAN-BUS protocol?
1. Disconnect negative (-) battery cable
2. Hook up power requirements as shown in Figure 1.
3. Daisy Chain the gauges together with Stereo Cables.
(Gauges can be daisy chained in any order. See Figure 2)
CAUTION: Do not connect the Daisy Chain while connected to a
powered OBDII system. Failure to do so will throw a check engine
code.
4. Mount gauge(s) for easy viewing. Use spin lock ring (included)
to mount to panel.
5. Reconnect negative (-) battery cable.
(sold seperatly)
Included in Gauge Set only (sold seperatly)
GF-HRNS-06
GF-HRNS-07
Wire Direct Note: Speedhut Freedom CAN-BUS gauges
(individual or daisy chained) will not function when
used in conjunction with any other OBDII device. Cycle
the gauge power to restore proper gauge function.
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanshipPlease contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING
(Main gauge power)
(Pointer (needle) lighting)
(Gauge Dial lighting) Note: E18-686-5CR is single gauge inverter to light single gauge
C01-18N-2 & C11-18A01 are multiple gauge lighting inverters that can light
up to 6 - 8 gauges depending on inverter model.
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
OBDII CAN (J1979) protocol Pinout:
If the vehicle has wires that connect to pins 6 and 14 of the
OBDII connector then the vehicle supports the CAN-BUS
(J1979) protocol.
Pin 4 -- Chassis Ground
Pin 5 -- Signal Ground
Pin 6 -- CAN High (data)
Pin 14 -- CAN Low (data)
Pin 16 -- +12volt Battery power (not for use as gauge power)
Vehicle’s OBDII connector pin numbering