Speedhut 2011-2012 Ford Mustang Replacement Pillar - Manual

Installation Instructions: 2011-2012 Ford Mustang Replacement Pillar
1. Remove the factory “A” pillar cover. Start by pulling down on the section closest to the rear of the car.
Then pull forward (towards you) on the section closest to the windshield.
2. Install provided plastic nut into oval slot.
3. On a flat surface using a hack saw, cut your factory "A" pillar.
Use the white reinforcing ribbing as a blade guide when cutting.
4. Reinstall the portion of the factory pillar that is furthest back (closest to the rear of the car).
You are now ready to install the replacement pillar and gauges.
5. Slide your new pillar into the place with a downward and forward motion.
6. After your new pillar is fully seated, pull the top portion out (towards you).
This will allow easy alignment of the provided screw into the plastic nut.
You may need to move the nut within the slot for proper fitment.
www.Speedhut.com Need help? Contact us: Speedhut Inc. 165 North 1330 West B2 Orem, Utah 84057 or call 801-221-1460
Model #12133 is designed to fit 2011-2012 Ford Mustang (Long screw and plastic nut)
Model #12133 is designed to fit 2011-2012 Ford Mustang (Long screw and plastic nut)
Installation Instructions: 2011-2012 Ford Mustang Replacement Pillar
1. Remove the factory “A” pillar cover. Start by pulling down on the section closest to the rear of the car.
Then pull forward (towards you) on the section closest to the windshield.
2. Install provided plastic nut into oval slot.
3. On a flat surface using a hack saw, cut your factory "A" pillar.
Use the white reinforcing ribbing as a blade guide when cutting.
4. Reinstall the portion of the factory pillar that is furthest back (closest to the rear of the car).
You are now ready to install the replacement pillar and gauges.
5. Slide your new pillar into the place with a downward and forward motion.
6. After your new pillar is fully seated, pull the top portion out (towards you).
This will allow easy alignment of the provided screw into the plastic nut.
You may need to move the nut within the slot for proper fitment.
www.Speedhut.com Need help? Contact us: Speedhut Inc. 165 North 1330 West B2 Orem, Utah 84057 or call 801-221-1460