Speedhut 2-1_16” GPS - LED Lighting - Manual

Peak recall button to recall peak
+12 Volts keyed ignition (Red)
(Black) Ground
(White) +12 Volts Dash lighting
Power distribution cable to plug all gauges into
Inverter
E18-686-5CR
C01-12L
C01-12N
Note: Tie together the
+12volt dash lighting white
wire to the +12 volt inverter
white wire and connect to
the same dash lighting
source.
+12Volts Hot Start (Red with black)
This feature draws very low current
and will not drain battery under normal use.
1. Hook up speedometer power requirements as shown above.
2. Plug GPS receiver antenna into back of speedometer.
3. For best performance, mount GPS antenna with as much view of sky as possible (preferably on the roof of the vehicle). The GPS antenna is
waterproof and magnetic. If the car’s roof is not accessible then mount the antenna on top of the vehicle’s dash with as much exposure as possible
to the sky through the window. (Antenna is able to receive signal through some thin materials i.e. wood, glass, fiberglass, and plastic. All types of
metal will block the signal.)
4. Hot start feature is optional. Hooking up the Hot start wire to constant +12volts allows GPS to quickly acquire satellites in less than 2 seconds.
This feature saves your current satellite position within the speedometer enabling it to quickly restore your position on power up when
The current draw is extremely low and will have virtually zero impact on a car battery’s charge.
Hotsart wire should be connected directly to battery +12volts and should remain powered 100% of the time.
2-1/16” GPS Instructions - LED Lighting
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship. Please contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
(Pointer (needle) lighting)
(Main gauge power)
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Please note that if the speedometer has been powered off longer than 4 hours, it could take up to 1 minute to acquire signal due to the satellites
moving significantly from your location. This is normal.