Speedhut Speedometer Sender - Manual

blue wire
brown wire
White wire
Black wire
Red wire
White wire
Black wire
Red wire
Sensor output
Ground
12volts power
Sensor output
Ground
12volts power
1. Hook up sender white wire to Speedometer harness white wire.
On some speedometer models the white wire will connect to a Yellow/Green wire.
2. Hook up sender black wire to speedometer harness black wire.
If no harness is supplied then ground the black wire to the chassis.
3. Run 12 volt power line (12volt accessory power) to red wire.
Note: this line is NOT included in harness and will need to be run as separate power line to sender.
For Ford and GM senders
GM style
Ford style
1. Hook up blue and brown wires to white and black wires from harness. This sender is NOT polarity sensitive.
If applicable: the Yellow/Green wire can be connected to either the Blue wire or the Brown wire.
Unused wire needs to grounded.
Once sender is connected to the speedometer follow the calibration instructions included with the speedometer.
Speedometer Sender Instructions
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship Please contact Speedhut service dept.
If you have a problem with this product. [email protected]
0.027” to 0.051” gap
0.7mm to 1.3mm gap
For the Universal Threaded Hall Effect sender