Speedhut 4 inch & 4-1_2 inch Dual GPS Speedometer_Fuel Level - Manual (Page 3)

Fuel level Setup menu
Note: This calibration can be done with sensor hooked up or NOT hooked up to gauge.
If sensor is hooked up to gauge, gauge will read the resistance of the sensor and
display this as a starting point. Pressing and holding button down on this menu will change
the resistance of the Fuel Empty setting. If fuel level sensor is hooked up to gauge, have tank
in empty state.
1. Press and hold button down while turning on GPS power to enter fuel setup menu.
Note: Antenna must be plugged into speedometer to Access this menu.
2. A quick button press will toggle LCD screen through all the available menu settings below.
3. Press and hold to select the menu item (2-3 seconds).
4. Press and hold button to change setting.
5. Release button and menu will be saved after 5 seconds.
Calibrate fuel empty.
Calibrate Fuel Empty.
240 ohms
Note: This calibration can be done with sensor hooked up or NOT hooked up to gauge.
If sensor is hooked up to gauge, gauge will read the resistance of the sensor and
display this as a starting point. Pressing and holding button down on this menu will change
the resistance of the Fuel full setting. If fuel level sensor is hooked up to gauge, have tank
in full state.
Calibrate fuel full.
Calibrate Fuel Full.
30 ohms
Note: Pointer will move up the fuel level dial. At the desired low warning point, release button
and setting will be saved after 5 seconds.
Set low fuel warning
Set warning point
!
Note: Press and release button to toggle through the brightness settings. There are 4
brightness settings including off.
Set day LED brightness
Set Day Brightness
Note: Press and release button to toggle through the brightness settings. There are 4
brightness settings including off.
Set night LED brightness
Set Night Brightness
Follow these steps below for all menu items