Snap-On Motorized Loader - Manual (Page 55)

4-11
Using the Multitest Toque Calbration System
Displaying or Downloading Data List
Torque measurements stored in the data list also include a date
and time stamp. For additional information on setting up printer
or PC ports, refer to Chapter 3—Set Up and Programming in
this manual.
Displaying Data List on LCD
1 Press RECALL DATA.
—
The LCD display reads:
RECALL
The present memory location is at the upper left,
the total number of memory locations to its right
and the time the data was stored at the far right.
— The LED display shows the measurement value of
that memory location while the LCD displays its
engineering units at the lower right.
2. Use up and down VALUE to view the data list.
3. Press ENTER to return to measurements mode.
Downloading Data List to Printer
1. Press RECALL DATA.
2. Press SEND/AUTO SEND.
— The LCD display reads:
Download - upper line
+DateTime Raw - lower line, with the plus sign flashing
Figure 4-5: Data Download Display
3. To download the data list plus date-time stamp, press
ENTER. The LED display reads:
SENDING
4. To download the raw data list, use right DIGIT to select
“Raw” on the LCD display.