Grain Systems Tanks PNEG-2400 - Manual (Page 40)

3. Bin Assembly
40 PNEG-2400 CFL Commercial Farm 4" Corrugation Externally Stiffened Grain Bin
Installing Door Latch Holders
The four (4) door latch holders secure the latches in place and keep the top and bottom doors closed.
1. Install four (4) door latch holders (WD-6234) to inner door frame using bolts (S-3728) and washers
(S-2120). (See Figure 3Z on Page 41.)
2. Use washers to adjust the latch holders position to align with door latches.
Tip
Start with five (5) washers and adjust quantity as needed.
Figure 3Y Latch door holder using washers for spacing.
Adjusting Inner Doors
The top and bottom inner doors must be level before fully tightened.
1. Adjust both inner doors so the bearing pins are centered in the corner holes on the doors.
(See Figure 3AA on Page 42.)
2. Close both doors and raise the latch bar over the latch holders.
3. Ensure both doors are firmly seated against the inner door frame.
4. Tighten all hardware that was previously left loose for adjustments.