Grain Systems Tanks PNEG-2400 - Manual (Page 36)

3. Bin Assembly
36 PNEG-2400 CFL Commercial Farm 4" Corrugation Externally Stiffened Grain Bin
Attaching Inner Doors to Hinges
1. Using two (2) or more people, lift inner bottom door (NCWT0378) aligning holes in door with holes in
hinges (NCWT0377). (See Figure 3U.)
2. Making sure bolt heads are towards the outside of the bin, insert bolts (S-277) through washer
(S-845), outer most holes in the hinges and fasten with nuts (S-396).
NOTE: Tighten bolts only finger tight.
3. Repeat for the inside bottom door.
Figure 3U Hinges Attached to Inner Door
Assembling Door Latch Bars
You can use the latch bars to open and close the inner doors.
1. Align reinforcement angles (NCWT0371) with the holes in the top inner door and hinges.
2. Making sure the bolt heads are towards the outside of the bin, insert bolts (S-275) through the holes
in the reinforcement brackets, top inner door and hinges then fasten loosely with a nut (S-396).
3. Install inside left (WD-6038) and right (WD-6037) panel latches to the reinforcement angles.
NOTE: Latches are located in the bottom holes for the top inner door and the top holes for the bottom
inner door. (See Figure 3V on Page 37 and Figure 3W on Page 38.)
4. Loosely fasten in place using bolts (S-277), latch bushings (WD-6040) and lock nuts (S-5220).
5. Install latch bars (NCWT0374) between the left and right panel latches using bolts (S-4303) and
nuts (S-3611).
6. Repeat for bottom inner door.