beautypg.com

Grain Systems Unload Augers PNEG-1049 User Manual

Page 26

background image

4. Assembly

26

PNEG-1049 10"-12" Commercial Bin Sweep Augers

31. Adjust the position of the motor clips, motor sheave and the aluminum enclosed drive sheave to

achieve proper alignment. Tighten all set screws.

32. Place the two (2) belts over the sheaves.

(See Figure 4W.)

Figure 4W Belts to Sheave

33. Adjust the position of the bottom motor straps to provide adequate tension on the drive belts.

The belts should allow 1/64" of deflection for every 1" of center distance between the two (2) shafts.

34. Close the front of the belt guard. Attach the front to the back with the two (2) 5/16" x 3/4" hex bolts

and nylock nuts that were previously removed.

(See Figure 4X.)

Figure 4X Close Belt Guard

See also other documents in the category Grain Systems Equipment: