Grain Systems PNEG-1717 - Manual (Page 55)

10. Service
PNEG-1717 CE Approved GSI/FFI Portable Dryer Manual 55
Figure 10A
14. Inspect entire dryer for loose, worn or damaged parts.
15. Check of auger flighting, metering rolls and other internal parts.
16. Check that temperature sensors within air plenum chamber are secured properly.
17. Check guards are installed and damage free.
18. Check all decals are fitted and legible.
19. Test fire the dryer several weeks ahead of the drying season. Check for possible gas leaks.
(See Page 32.)
NOTE: If on site bearing lubrication is to be performed, see lubrication instructions for ball bearing
motors. To keep motor bearings properly lubricated, and dispel any accumulation of
moisture within the windings, the fan and auger motors should be operated for 15 to 30
minute each month.