Grain Systems PNEG-1717 - Manual (Page 36)

36 PNEG-1717 CE Approved GSI/FFI Portable Dryer Manual
8. Vision/Dri-Tek Dryer Operation
Full Heat Drying
Full heat drying discharges hot grain. This yields higher drying capacity, but requires cooling elsewhere.
Final Moisture
Cooling will remove up to 3% additional moisture. The target moisture should be increased to allow for this
to prevent over drying.
Drying Temperatures
Recommended temperatures are as follow:
Drying efficiency is maximized by using highest possible temperatures, subject to avoiding product
damage/quality losses.
Dryer shut down, if still full, should be preceded by cooling for 10-15 minute to prevent water vapor
condensation and freezing in low temperatures.
Initial Setup Parameters
Power-up the dryer and press Start Dryer on the touch screen.
Timer and Delay Settings
To set the timers, touch the button at the bottom of Operation screen. The Select Timers to Modify
screen will appear. Refer to PNEG-1710 for instructions to set the timer and delays.
Setting the Temperatures
Press button on the Operation screen. Follow screen instructions to set plenum temperatures.
Start-Up
Follow pre-season checks in Service Chapter on Page 54 .
Drying mode options are:
1. Regulation of Grain Temperature on Page 37 .
2. Regulation of Moisture: 5 MR SP on Page 41 .
3. Regulation of Moisture: Variable MR SP (not recommended for single module dryers).
Product Top Fan Bottom Fan
Shelled Corn 110°C 84°C
Soybeans 54°C 54°C
Wheat, Barley, Milo, Oats 66°C 66°C