Rough Country 875.20 - Manual (Page 9)

33. Install the supplied sleeves in the sway bar links and install on the sway bar and control arm using 19mm wrench
and the supplied 12mm x 65mm bolts, washer s and flange lock nuts. See Photo 32.
34. Reinstall axle shafts per disassembly markings using 14mm socket. See Photo 33. (4WD ONLY)
35. Install the kicker brackets on the rear cross-member using the 1/2” x 1” bolts, washers and nuts. See Photo 34.
36. Install bushings and sleeve into rear kicker braces. Install new kicker brace using two supplied 1/2 x 3 1/2” bolts,
washers & nuts. See Photo 35.
37. Swing the kicker bar up to the cross member and secure them with the supplied 5/8 x 2 1/2” bolts, washers & nuts .
See Photo 36 & 37. Tighten 1/2 bolts using 19mm wrench and rear 5/8 bolts with 24mm wrench. Caution do not
over tighten rear bolts ,as it will crush trans cross-member. Torque to 35 ft lbs.
Photo 33
Photo 35
Photo 36 Photo 37
Re- Install Front Axles
Install Kickers to Back Side of Rear Cross Member
Install Kickers to Factory Cross Member on Pass Side Install Kickers to Factory Cross Member on Driver Side
Photo 32
Install Supplied
New Front Sway
Bar Links
Photo 34